USB
  cp2102 evm board not detected

Post New Topic  Post A Reply
profile | register | preferences | faq | search

UBBFriend: Email This Page to Someone! next newest topic | next oldest topic
Author Topic:   cp2102 evm board not detected
deepikarai1234
New Member 		posted September 02, 2010 01:49 AM     Click Here to See the Profile for deepikarai1234   Click Here to Email deepikarai1234     Edit/Delete Message
hi,
actuallt i am trying to connect my trf 7960 evm board to my pc. i hav installed usb to serial bridge software from silabs on my pc. but the board is not getting detected. on gui it show
*** time out***
***com port not found. check com port***

IP: Logged

egawtry
Member 		posted September 02, 2010 09:39 AM     Click Here to See the Profile for egawtry   Click Here to Email egawtry     Edit/Delete Message
Isn't the trf 7960 from TI? Why would it work with the SiLabs software?

IP: Logged

Scotty
Member 		posted September 03, 2010 12:08 AM     Click Here to See the Profile for Scotty     Edit/Delete Message
@egawtry:
Isn't the trf 7960 from TI? Why would it work with the SiLabs software?
Because the USB connection is made via CP2102

@deepikarai1234:
i hav installed usb to serial bridge software from silabs on my pc. but the board is not getting detected.
You've to clarify: The board is not detected by the TRF7960 software, or the CP2102 is not recognized by Windows?
If the CP2102 is properly recognized by Windows, I'd assume that the MSP430 has no or the wrong firmware to communicate with the EVM-Software.
If the CP2102 is not recognized, you must dig into it... Which drivers have you used? Does TI provide their own driver package for the CP2102?

Regards,

Scotty

IP: Logged

All times are CT (US)

next newest topic | next oldest topic

Administrative Options: Close Topic | Archive/Move | Delete Topic
Post New Topic  Post A Reply
Hop to:

Contact Us | MCU User Forum

Have you seen our MCU Knowledge Base?


Ultimate Bulletin Board 5.47b